Certification
5.1.3FCC
The device is marked with a CE marking and can be used throughout the European
community.
A copy of the CE Declaration of Conformity is available from Siemens AG. For contact
information, refer to "Contacting Siemens (Page vi)".
5.1.3 FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to
correct the interference on his own expense.
5.1.4 FDA/CDRH
This device meets the requirements of the following U.S. Food and Drug
Administration (FDA) standard:
• Title 21 Code of Federal Regulations (CFR) – Chapter I – Sub-chapter J –
Radiological Health
5.1.5 ISED
This device is declared by Siemens AG to meet the requirements of the following
ISED (Innovation Science and Economic Development Canada) standard:
• CAN ICES-3 (A)/NMB-3 (A)
5.1.6 ISO
This device was designed and manufactured using a certified ISO (International
Organization for Standardization) quality program that adheres to the following
standard:
• ISO 9001:2015
Quality management systems – Requirements
28
RUGGEDCOM RMC20
Installation Manual, 04/2021, C79000-G8976-1007-10
To Next Page
Loading...
Need help?
General
