Siemens RUGGEDCOM RSG910C - Configuring the Device

Device Management
3.2Configuring the Device
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RSG910C console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RSG910C is https://-
192.168.0.1.
For more information about available ports, refer to "Communication Ports (Page
21)".
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RSG910C interface. For
more information about configuring the device, refer to the RUGGEDCOM RSG910C
User Guide associated with the installed software release.
20
RUGGEDCOM RSG910C
Installation Manual, 02/2020, C79000-G8976-1405-06