Technical Specifications
5.4Copper Ethernet Port Specifications
Standard 10 Mbps Ports 100 Mbps
Ports
1000 Mbps
Ports
Description
IEEE
1588-2008
ü ü ü
Precision Time Protocol (PTP)
Version 2
IEC
62439-2:2016
ü ü
Media Redundancy Protocol
(MRP)
IEC
62439-3:2016
ü ü ü
High-Availability Seamless Re-
dundancy (HSR), Parallel Redun-
dancy Protocol (PRP)
5.4 Copper Ethernet Port Specifications
The following details the specifications for copper Ethernet ports that can be ordered
with the RUGGEDCOM RSG910C.
Speed
a
10/100/1000Base-TX
Connector RJ45
Duplex
a
FDX/HDX
Cable Type
b
> CAT 5
Wiring Standard
c
TIA/EIA T568A/B
Maximum Distance
d
100 m (328 ft)
Isolation
e
1.5 kV
a
Auto-negotiating.
b
Shielded.
c
Auto-crossover and auto-polarity.
d
Typical distance. Dependent on the number of connectors and splices.
e
RMS 1 minute.
5.5 Operating Environment
The RUGGEDCOM RSG910C is rated to operate under the following environmental
conditions.
Ambient Operating Tempera-
ture
a
b
-40 to 85 °C (-40 to 185 °F)
Ambient Storage Temperature -40 to 85 °C (-40 to 185 °F)
Ambient Relative Humidity
c
5% to 95%
Maximum Altitude 2000 m (6562 ft)
a
Measured from a 30 cm (12 in) radius surrounding the center of the enclosure.
b
Operating temperature may vary based on the limitations of installed SFPs. Refer to the RUGGEDCOM
SFP Transceivers Catalog for SFP temperature ratings.
c
Non-condensing.
RUGGEDCOM RSG910C
Installation Manual, 02/2020, C79000-G8976-1405-06
27
To Next Page
Need help?
General
