6.2 Basic display
When switching power on, the displays show hyphens for about 5 seconds.
RWF50.X
7866z11/0112
Figure 17: Display start
The state that follows is called normal display.
Default display is the actual value and the current setpoint.
Other values can be displayed at the configuration level or via PC software ACS411.
Reference!
See chapter 8.6 Display diSP.
Manual control, self-setting, the user, parameter and configuration levels can be
activated from here.
Basic display
Enter
7866d11e/0212
Enter
Setpoint increase
(factory-set)
SP1
Setpoint reduce
(factory-set)
SP1
ESC
>2 s
or timeout
Enter
OPr
Enter
User level
OPr
SP1 SP2 dSP
InP Y
Editable: , or
Only display: ,
Navigation principle
Enter
ESC
One level back One level
down
Next/previous parameter
PArA
ConF
Figure 18: Basic display
To Next Page
Loading...
