6.3 User level
This level is started from the basic display.
Setpoints SP1, SP2 or dSP can be altered.
*
From the basic display, press
so that OPr appears
*
Press so that SP1 appears
*
Press and SP1 flashes
*
Press
or
to adjust the required setpoint and press
to confirm
Timeout after about 180 seconds.
Note!
If the setpoint is not stored, the basic display changes after the timeout tout and the
former setpoint is maintained.
The value changes only within the permitted range.
Changing the setpoints
Timeout
To Next Page
Loading...
