Siemens S65 - Security; Auto key lock; Direct call; Codes

©
Siemens AG 2003, M:\Mobil\R65\S65_Penelope\am\fug\_von_itl\S65_Security.fm
103Setup
VAR Language: am; VAR issue date: 040517
left page (103) of S65 FUG us, A31008-H7400-A40-1-4A19 (02.06.2004, 19:50)
Setup
Security
C ¢T¢Security
¢Select function.
Auto key lock
The keypad is locked automatically if
no key has been pressed for one
minute in standby mode. This pre-
vents the phone from being used ac-
cidentally. However, you can still be
called and you can still make an
emergency call.
Direct call
(Phone-code protected)
Only one phone number can be
dialed(see also p. 37).
Only ‚ b
(PIN2 or phone-code protected)
Dialing options are limited to SIM-
protected phone numbers in the
Phonebook. If only area codes are
entered, relevant phone numbers
can be added to these manually be-
fore dialing.
If the SIM card does not support
PIN 2 input, the whole Phonebook
can be protected with the phone
code.
Codes
For description, see p. 27:
PIN control, Change PIN, Change PIN2,
Chg.phonecode
This SIM only b
(Phone-code protected)
The phone can be connected to a
SIM card once the phone code is en-
tered. Unless the phone code is
known, the phone will not operate
with a different SIM card.
If the phone is to be used with a dif-
ferent SIM card, enter the phone
code when requested.
Additional information
The keypad can also be locked and un-
locked directly in standby mode.
In each case:
#
Press and hold.