Siemens S65 - Call setup; Hide ID; Divert

©
Siemens AG 2003, M:\Mobil\R65\S65_Penelope\am\fug\_von_itl\S65_CallSetup.fm
Setup92
VAR Language: am; VAR issue date: 040517
left page (92) of S65 FUG us, A31008-H7400-A40-1-4A19 (02.06.2004, 19:50)
Setup
Call setup
C ¢T¢Call setup
¢Select function.
Hide ID b
When you make a call, your phone
number can be displayed on the re-
cipient's display (depending on the
service providers).
To suppress this display, you can en-
able the "Hide ID" mode for all subse-
quent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting b
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify the conditions for
which calls should be forwarded to
your mailbox or other numbers.
Status check
You can check the current forward-
ing status for all conditions. After a
short pause, the current situation is
transmitted via the network and dis-
played.
Ö Condition set.
Õ Not set.
Ô Display if status is un-
known (e.g. with a new
SIM card).
Clear all
b
All set forwarding is cleared.
Set up call forwarding (example)
The most common condition for call
forwarding is, for example:
Unanswered
b
I
Select Unanswered.
(Includes the conditions
Not reachable, No reply,
Busy, see below.)
C Confirm.
Set Select.
C Confirm.
Ï
/
J
Select or enter the phone
number to which the calls
are to be forwarded.
§Mailbox§ Use existing mail-
box phone numbers, or
enter them if necessary.
C
Confirm. After a short
pause, the setting is con-
firmed via the network.