Siemens S65 - Page 37

©
Siemens AG 2003, M:\Mobil\R65\S65_Penelope\am\fug\_von_itl\S65_Phone.fm
Calling36
VAR Language: am; VAR issue date: 040517
left page (36) of S65 FUG us, A31008-H7400-A40-1-4A19 (02.06.2004, 19:50)
Incoming calls during a call
You may need to register for this ser-
vice with your service provider and
set your phone accordingly (p. 92).
During a call, you may be advised
that there is another call waiting. You
will hear a special tone during the
call. You have the following options:
• Accept the waiting call in addition
to the first
§Toggle§ Accept the waiting call,
putting the current call on
hold to do so.
Always proceed as above to swap
between the two calls.
• Reject the waiting call
§Reject§ Press.
Or
§Divert§ The waiting call is for-
warded, for example, to
the mailbox.
• Accept the waiting call and end the
current call
B
End the current call.
C
Accept new call.
End call(s)
B
Press the End key.
After the Return to held call? display,
you have the following selection:
§Yes§ You accept the call on hold.
§No§ You end the second call
too.
Conference
Call up to 5 parties one by one and
link them together in a multiparty
call. Some of the functions described
may not be supported by your ser-
vice provider or may have to be spe-
cially enabled.
A connection has already been es-
tablished:
C
Open the call menu and
select Hold. The current
connection is maintained.
J
Now dial a new number.
When the new connec-
tion is established ...
C
... Open the call menu and
select Conference. The
held call is joined.
Repeat procedure until all partici-
pants are linked together (up to
5participants).
End
B
All calls in the conference
call are ended when you
press the End key.