Siemens S7-1200 - Page 25

4 Configuration/Engineering
EtherNet/IP Scanner
Entry-ID: 109782314, V1.1.0, 04/2021
25
© Siemens AG
2021 All rights reserved
Table 4-4: LCCF_EnetScanner block parameterization
Step
Instruction
Result
1.
Verify that the EnetIoSystem data
block contains at least two variables.
The variable “adapters” contains the just
prepared description for the ET200SP
MF.
The second variable contains the data
areas to exchange the data with the
adapters.
2.
Extend the “adapters” array to
accommodate 2 adapters.
Confirm your entry
You will get a new entry for the second
adapter.
3.
Enter the IP address of the second
adapter.
In this document it is the S7-1200 with
192.168.74.45