Siemens SCALANCE W748-1 RJ-45 - Dot1 X RADIUS Server Settings

Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
114 Configuration Manual, 08/2018, C79000-G8976-C267-13
6.3.1.12
Dot1x RADIUS Server Settings
Introduction
On this Basic Wizard page, you configure the settings for the primary RADIUS Server.
After completing the Basic Wizard, you can configure a backup server and other settings, for
example the number of logon attempts with "Security> WLAN > AP Radius Authenticator.
Note
This page is available only i
n access point mode.
Description
This table contains the following columns:
●
Server Role
Shows the role of the server.
●
Server IP Address
Enter the IP address of the RADIUS server. The use of the computer name (name
resolution using DNS) instead of the IP address is not supported.
●
Server Port
Enter the port of the RADIUS server.
●
Shared Secret
Enter the password of the RADIUS server.
●
Shared Secret Conf
Enter the password again in this input box.