Siemens SCALANCE W748-1 RJ-45 - Allowed Addresses

Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
402 Configuration Manual, 08/2018, C79000-G8976-C267-13
●
Activate
When enabled, the access restriction is used. You configure which devices are
accessible to the clients in "Security > Inter AP Blocking >Allowed Addresses".
●
Block Gratuitous ARP Requests
When enabled, gratuitous ARP packets are not forwarded.
●
Block Non-IP Frames
When enabled, there is no exchange of non-IP packets, for example layer 2 packets
between the client and the devices configured on the access point as permitted
communications partners.
6.9.8.2
Allowed Addresses
Note
•
This WBM page is only available in access point mode.
•
This WBM page can only be configured with the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
–
W700 Security (MLFB 6GK5907-0PA00)
On this WBM page you specify which SCALANCE W700 devices are accessible to the
clients.