Configuring with Web Based Management
6.3 "Wizard" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
93
Basic Wizard
Introduction
With the Basic Wizard, menus guide you through the configuration of the most important
parameters.
On the Basic Wizard pages, you can only configure the parameters important for the basic
functionality. You make further settings when you have finished with the Basic Wizard.
● The device is in the status it was when it was shipped and can be reached via the
Ethernet interface.
● You have assigned an IP address to the device. For more detailed information, refer to
the section "IP addresses (Page 77)".
● You are logged on in WBM as the "admin" user. For more detailed information, refer to
the section "Login (Page 89)".
Starting the Basic Wizard
Click on "Wizard > Basic Wizard" in the navigation area to start the Basic Wizard.
If you log on the first time or log on after a "Restore Memory Defaults and Restart", the Basic
wizard is always started automatically after you have changed the default password.
Buttons you require often
The WBM pages of the Basic Wizard contain the following buttons:
Goes to the next page
Goes back to the previous page
The Basic Wizard is closed without adopting the settings.
Saves the configuration and exits the Wizard.
Navigation within the pages of the Basic Wizard is possible only with the "Prev" and "Next"
buttons.
To Next Page
Loading...
Need help?
General
