Siemens SCALANCE W748-1 RJ-45 - Page 155

Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
155
Description
The table has the following columns:
●
Radio
Shows the available WLAN interfaces.
●
Port
Shows the port.
●
BSSID
● Shows the MAC address of the WDS partner.
●
WDS ID
Shows the name of the WDS partner.
●
Channel
Shows the channel over which the access point communicates with the WDS partner.
●
Signal Strength [dBm]
Shows the signal strength of the connected access point in bBm.
●
Signal strength [%]
Shows the signal strength of the connected access point as a percentage.
●
Security
Shows which authentication method is used.
– If the authentication method "Open System + Encryption" or "Shared Key" is used, the
"Encrypted (WEP/AES)" is displayed for both authentication methods.
– If iPCF, iPCF-HT or iPCF-MC mode is enabled on a WLAN interface, the following is
displayed depending on the encryption status:
iPCF Encrypted (AES): Encryption is enabled.
iPCF authentication: Encryption is disabled.
●
Max. Data Rate (Mbps)
Shows the maximum data transmission speed for the relevant WDS partner.
●
State
Shows the current status of the WDS connection.