Siemens SCALANCE W748-1 RJ-45 - Page 157

Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
157
The table has the following columns:
●
Radio
Shows the available WLAN interfaces in this column.
●
Type
Shows the mode of the WLAN interface.
●
SSID
Shows the SSID of the access point.
●
BSSID
Shows the MAC address of the access point.
●
System Name
Shows the system name of the SCALANCE W700-Geräts. The entry depends on the
access point. Not all access points support this parameter.
●
Channel
Shows the channel over which the client communicates with the access point.
●
Signal Strength [dBm]
Shows the signal strength of the client in bBm.
●
Signal strength [%]
Shows the signal strength of the client as a percentage.
●
Age [s]
Shows the time that has elapsed since the last access point activity.
●
Security
Shows which authentication method is used.
– If the authentication method "Open System + Encryption" or "Shared Key" is used, the
"Encrypted (WEP/AES)" is displayed for both authentication methods.
– If iPCF, iPCF-HT or iPCF-MC mode is enabled on the WLAN interface, the following is
displayed depending on the encryption status:
iPCF Encrypted (AES): Encryption is enabled.
iPCF authentication: Encryption is disabled.
●
WLAN Mode
Shows the transmission standard. If DFS is activated, the transmission standard
"802.11h" is not shown additionally but only the configured transmission standard
"802.11a" or "802.11n".