Siemens SCALANCE W748-1 RJ-45 - Page 212

Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
212 Configuration Manual, 08/2018, C79000-G8976-C267-13
Table 2 has the following columns:
●
Event
The column contains the following values:
–
Cold/warm restart
The device was turned on or restarted by the user.
–
Link Change
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
–
Authentication error
This event occurs when attempting access with a bad password.
– Power Change
This event occurs only when power supply lines 1 and 2 are monitored. It indicates
that there was a change to line 1 or line 2. The event occurs when the PoE power
supply has failed, see "System > Fault Monitoring > Power Supply".
– Spanning Tree Change
The STP or RSTP or MSTP topology has changed.
– Fault State Change
The fault status has changed. The fault status can relate to the activated port
monitoring, the response of the signaling contact or the power supply monitoring.
– Overlap AP Detection (only in access point mode)
This event is triggered when there is an entry in the Overlap AP list.
– WDS (Only in access point mode)
The connection status of a WDS link has changed.
– DFS (Only in access point mode)
This event occurs if a radar signal was received or the DFS scan was started or
stopped.
– WLAN Authentication Log
Forwarding of the entries from the WLAN authentication log to the system protocol
server.
– WLAN De/Authentication(Only in client mode)
With successful or failed WLAN authentication attempts.
– iPCF Cycle Time (Only in access point mode)
Only available when the KEY-PLUG is inserted.
This event occurs if too many clients are logged on for the set iPCF cycle time or if
some clients were not reached in one cycle.
– iPCF Poll Size
Only available when the KEY-PLUG is inserted.
This event occurs if the PROFINET data size is too large for transfer.
– WLAN General (Only in access point mode)
This event occurs if a the channel bandwidth has changed.
– Configuration Change
This event occurs when the configuration of the device has changed.