EasyManuals Logo

Siemens SCALANCE W748-1 RJ-45 User Manual

Siemens SCALANCE W748-1 RJ-45
456 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Description
2.6 C-PLUG and KEY-PLUG
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
34 Configuration Manual, 08/2018, C79000-G8976-C267-13
License information on the KEY-PLUG
In addition to the configuration, the KEY-PLUG also contains a license that allows the use of
the iFeatures.
PLUG with preset function (PRESET-PLUG)
With PRESET-PLUG it is possible to install the same configuration and the firmware
belonging to it on several devices.
Note
Using configurations with DHCP
Create a PRESET
-PLUG only from device configurations that use DHCP. Otherwise
disruptions will occur in network operation due to multiple identical IP addresses.
You assign fixed IP addresses extra following the basic installation
.
In a PLUG that was configured as a PRESET-PLUG, the device configuration, user
accounts, certificates and the firmware are stored.
Note
Restore factory defaults and restart with a PRESET PLUG inserted
If you reset a device to the factory defaults,
when the device restarts an inserted PRESET
PLUG is formatted and the PRESET PLUG functionality is lost. You then need to create a
new PRESET PLUG.
We recommend that you remove the PRESET PLUG before you reset the device to the
factory settings.
For more detailed information on creating and using a PRESET PLUG refer to the section
Upkeep and maintenance (Page 421).

Table of Contents

Other manuals for Siemens SCALANCE W748-1 RJ-45

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W748-1 RJ-45 and is the answer not in the manual?

Siemens SCALANCE W748-1 RJ-45 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W748-1 RJ-45
CategoryWireless Access Point
LanguageEnglish

Related product manuals