Siemens SCALANCE W748-1 RJ-45 - Page 391

Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
391
Description
The table has the following columns:
●
Rule Number
Shows the number of the protocol rule. When you create a rule, a new row with a unique
number is created.
●
Protocol
Select the protocol for which this rule is valid.
●
Protocol Number
Enter a protocol number to define further protocols.
This box can only be edited if you have set "Other Protocol" for the protocol .
●
Source Port Min.
Enter the lowest possible port number of the source port.
This box can only be edited if you have set "TCP" or "UDP" for the protocol.
●
Source Port Max.
Enter the highest possible port number of the source port.
This box can only be edited if you have set "TCP" or "UDP" for the protocol.
●
Dest. Port Min.
Enter the lowest possible port number of the destination port.
This box can only be edited if you have set "TCP" or "UDP" for the protocol.
●
Dest. Port Max.
Enter the highest possible port number of the destination port.
This box can only be edited if you have set "TCP" or "UDP" for the protocol.
●
Message Type
Enter a message type to decide the format of the message.
This box can only be edited if you have set "ICMP" for the protocol.
●
Message Code
Enter a message code to specify the function of the message.
This box can only be edited if you have set "ICMP" for the protocol.
●
DSCP
Enter a value for classifying the priority.
This box cannot be edited if you have set "ICMP" for the protocol.