Siemens SCALANCE W748-1 RJ-45 - Page 393

Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
393
●
Add
To permanently assign the ACL rule to the interface, click the "Add" button. The
configuration is shown in the table.
●
Remove Rule
From the "Remove rule" drop-down list, select the ACL rule to be deleted.
●
Remove
To remove the ACL rule from the interface, click the "Remove" button.
The table has the following columns:
●
Rule Order
Shows the order of the ACL rules.
●
Rule Number
Shows the number of the ACL rule.
●
Protocol
Shows the protocol for which this rule is valid.
●
Protocol Number
Shows the protocol number.
●
Source IP
Shows the IPv4 address of the source.
●
Source Subnet Mask
Shows the subnet mask of the source.
●
Dest IP
Shows the IP address of the destination.
●
Dest. Subnet Mask
Shows the subnet mask of the destination.
●
Action
Select whether the frame is forwarded or rejected when it corresponds to the ACL rule.
– Forward
If the frame complies with the ACL rule, the frame is forwarded.
– Discard
If the frame complies with the ACL rule, the frame is not forwarded.
●
Source Port Min.
Shows the lowest possible port number of the source port.
●
Source Port Max.
Shows the highest possible port number of the source port.
●
Dest. Port Min.
Shows the lowest possible port number of the destination port.
●
Dest. Port Max.
Shows the highest possible port number of the destination port.