Siemens SCALANCE W748-1 RJ-45 - Page 451

Appendix D
D.1 Messages in the event log
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
451
Alarm
Description
Startup configuration: Internal storage
PLUG: Configuration not accepted
PLUG: License missing
Invalid or incompatible configuration on the inserted PLUG.
There are functions configured on the device for which a license (KEY-
PLUG) is required.
Startup configuration: Internal storage
PLUG: Factory clean → filled with internal con-
figuration
PLUG: Configuration accepted
PLUG: License accepted
The internal configuration was written successfully to an empty KEY-
PLUG.
Startup configuration: Internal storage
PLUG: Factory clean → filled with internal con-
figuration
PLUG: Configuration accepted
The internal configuration was written successfully to an empty C-
PLUG.
Startup configuration: PLUG storage
PLUG: Configuration accepted
PLUG: License accepted
The configuration was loaded successfully from the KEY-PLUG.
Startup configuration: PLUG storage
PLUG: Configuration accepted
The configuration was loaded successfully from the C-PLUG.
Messages about PLUG
Messages
Description
An empty PLUG was found.
There is an empty or formatted PLUG in the device.
PLUG: Filled PLUG was found.
PLUG: Configuration Accepted
There is a valid PLUG with a valid configuration in the de-
vice.
PLUG: Removed at runtime.
The C-PLUG / KEY-PLUG was removed during operation.
PLUG accepted. PLUG was accepted.
Messages about digital input/output
Messages
Description
Digital output is open / closed.
The digital output is open or closed (device dependent).
Value of digital input is 0 / 1.
A low or a high signal is applied to the digital input.