SCALANCE X-300
Compact Operating Instructions, 05/2016, A5E00982643-14
11
Note the following safety notices. These relate to the entire working life of the device.
You should also read the safety notices relating to handling in the individual sections,
particularly in the sections "Installation" and "Connecting up".
Use of approved components
Use of approved components
• Use only approved components, for example supporting brackets, SFPs, 19 inch racks.
• Create any supports you require according the dimension drawing.
Safety notices on use in hazardous areas
General safety notices relating to protection against explosion
DO NOT OPEN WHEN ENERGIZED.
Safety notices when using the device according to Hazardous Locations (HazLoc)
If you use the device under HazLoc conditions you must also keep to the following safety
notices in addition to the general safety notices for protection against explosion:
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D or non-
hazardous locations only.
This equipment is suitable for use in Class I, Zone 2, Group IIC or non-hazardous locations
only.
To Next Page
Loading...
