Accessories
4.4 Plug-in and draw-out technology
3VA molded case circuit breakers with IEC certificate
Manual, 03/2019, A5E03603177010-03
275
Overview of variants / products
Installation overview
3-pole and 4-pole 3VA molded case circuit breakers are available in a version for fixed
mounting, as a plug-in version and a draw-out version, as shown in the table below:
Apart from the complete kit for plug-in or draw-out technology, a plug-in or draw-out
"conversion kit" for the 3VA molded case circuit breaker can be ordered as a separate item.
These conversion kits are used to prepare 3VA molded case circuit breakers in advance so
that ready-assembled units are available at short notice in the event that a defective breaker
needs to be replaced.
To Next Page
Loading...
