Accessories
4.4 Plug-in and draw-out technology
3VA molded case circuit breakers with IEC certificate
Manual, 03/2019, A5E03603177010-03
299
Signal "Plug-in unit - MCCB correctly bolted to plug-in socket"
This option is provided for plug-in units only. Depending on the socket size, up to two
position signaling switches can be installed in slot No. 46.
Slot 46 for position signaling switch of the plug-in socket
Slot 46 for position signaling switch of the plug-in socket
Mechanical system for actuation of position signaling switches when the bolt is tightened
Bolt hole which determines the signal output by the position signaling switches
With this application, the position signaling switches indicate whether the molded case circuit
breaker is inserted in the plug-in socket and secured by at least one bolt. The reason for this
application is that the molded case circuit breaker needs to be secured in position by
mounting screws in the plug-in socket. The four mounting screws supplied with the complete
kit for plug-in technology must be used for this purpose.
To Next Page
Loading...
