Siemens SIMATIC 200SP - Page 15

Module overview of ET 200SP
1.2 CPUs
Product information on the documentation of the ET 200SP distributed I/O system
Product Information, 09/2019, A5E03799595-BD
15
Note
The CM AS
-i Master ST and F-CM AS-
i Safety ST communication modules are supported as
of firmware V1.8 of the CPUs. Note the following addi
tional requirements:
CM AS-i Master ST:
•
Firmware version of the CM AS-i Master ST: V1.1
•
STEP 7 (TIA Portal): V13 SP1 Update 4 or higher
F-CM AS-i Safety ST
•
Firmware version of the CM AS-i Safety ST: V1.0
•
STEP 7 (TIA Portal): as of V13 SP1 Update 4 and HSP0070 V3.0