Siemens SIMATIC 6DL1131-6DF00-0PK0 - Diagnostics, Missing Supply Voltage L; Diagnostics, Wire Break; Wire-Break Check; Input Delay

6.4.2 Diagnostics, Missing supply voltage L+
De󹪝nition
Enabling of the diagnostics for missing or insu󹪟cient supply voltage L+.
6.4.3 Diagnostics, Wire break
De󹪝nition
With activated wire break checking, the diagnostics are enabled when the line is from the
actuator is interrupted.
6.4.4 Wire-break check
De󹪝nition
Enable for wire break check. The I/O module can only detect a wire break if wire-break is
activated.
6.4.5 Input delay
De󹪝nition
This parameter can be used to avoid signal faults. Changes to the signal are only detected if they
are constantly pending longer than the set input delay time.
6.4.6 Hardware interrupts positive edge
De󹪝nition
Speci󹪝es if a hardware interrupt should be generated for a rising edge.
6.4.7 Hardware interrupts negative edge
De󹪝nition
Speci󹪝es if a hardware interrupt should be generated for a negative edge.
Parameters
6.4 Explanation of the module/channel parameters
DI 8x24...125VDC HA
Equipment Manual, 10/2021, A5E39288633-AD 21