Siemens SIMATIC C7-635 - Mechanically Fastening the C7-635 Touch; Dimension Drawings for the C7-635 Touch (Measurements in MM)

Installing and Wiring the C7-635
3-4
C7-635 Control System
A5E00155581-04
Table 3-1 Mechanical Installation, continued
Step Action
5. Using a screwdriver, tighten the C7-635 evenly and crosswise from behind
in the control cabinet door until the front panel of the C7-635 rests on the
control cabinet door Á. Situate the device so that there is even spacing on
all sides between the housing and the cutout section ®.
1
2
3
Control
cabinet
door
Figure 3-2 Mechanically Fastening the C7-635 Touch
199
260
79
231
+1.0
183
+1.0
Cutout in control
cabinet door
Figure 3-3 Dimension Drawings for the C7-635 Touch (Measurements in
mm)