Product Overview
2-8
C7-635 Control System
A5E00155581-04
2.2 C7-635 Components and Accessories
Components
The following components are supplied with the C7-635:
• 1 C7-635 Touch (6ES7635-2EB01-0AE3) with sealing or
1 C7-635 Key (6ES7635-2EC01-0AE3) with sealing
• 1 grounding busbar, including two mounting screws and six shielding terminals
• 10 brackets
Additional Devices and Tools Required to Operate the C7-635
You need the following devices and tools:
• A Micro Memory Card (MMC) to store the CPU user program that is
programmed with STEP 7. The C7-635 can only be operated with an MMC.
• A Compact Flash Card (CF Card) for the TP/OP if you require more than
32 Kbytes of memory for recipes or if the C7-635 is to be replaceable without a
programming device/PC
• 24 V power supply
• Connector set (screw terminals or spring-type terminals) for C7 I/O with coding
profiles and coding tabs
• C7-635 accessory for I/O expansion (directly on the device, or at a distance of
1.5 m), in case you would like to expand the I/O.
• A programming device or PC with:
– An MPI interface and an MPI cable to generate the user program, or
alternatively, a programming device/PC with the capability of reading and
writing to a CF Card
– An RS232 interface and RS232 cable (zero modem cable)
• For C7-635 Touch, STEP 7 as of Version 5.2 + Service Pack 1 + Hardware
Update C7-635 Touch V2.0
• For C7-635 Key, STEP 7 as of Version 5.2 + Service Pack 1 + Hardware
Update C7-635 Key V2.0
• The configuration tool ProTool, ProTool/Lite or ProTool/Pro starting with
V 6.0 + Service Pack 1
To Next Page
Loading...
