Siemens SIMATIC ET 200pro - Addressing Digital Electronic Modules

Configuring
5.2 Configuring the CPU
CPU 1516pro-2 PN (6ES7516-2PN00-0AB0)
Operating Instructions, 11/2019, A5E35873416-AC
41
5.2.2.2 Addressing digital electronic modules
Introduction
The following section describes the addressing of the digital electronic modules. You need
the addresses of the channels of the digital electronic module in the user program.
Addresses of the digital electronic modules
The address of an input or output of a digital electronic module is composed of the byte
address and the bit address. The channels of the digital electronic modules are assigned bit
addresses.
Example: I 1.2
The example consists of:
I
Input
-
1
Byte address
The byte address depends on the module start address
2
Bit address
You read the bit address from the module
When you insert a digital electronic module into a free slot, STEP 7 assigns a default
address. You can change the proposed default address in STEP 7.