Siemens SIMATIC HMI TP 070 - SIMATIC S7 Communication Management; General Info and Installation

7-1
TP 070 Equipment Manual
Release 03/00
Communication Management
for SIMATIC S7
In this chapter
This chapter describes the communication between the TP 070 and the
SIMATIC S7-200 PLC system.
General information
The connection of the TP 070 to the CPU of the SIMATIC S7-200 concerns a
point–to–point connection with the protocol profile DP/T.
Installation
The driver for connecting the SIMATIC S7-200 is supplied with the configuration
software and installed automatically.
Connection of the TP 070 to the SIMATIC S7-200 is basically restricted to the
physical connection of the operating unit. Special function blocks for connection to
the PLC are not required.
7