Mounting and connecting the HMI device
3.1 Preparation for mounting
Comfort Panels
Operating Instructions, 03/2012, A5E03404994-02
35
Procedure
Proceed as follows:
1. Edit the template on a PC and then print it.
2. Apply a fixing spray film to the labeling strips.
The printout can be made water and smudge-proof with a fixing spray. The color printer
ink will not bleed onto the keyboard foil as well.
3. Cut out the labeling strip.
4. Ensure that the corners are cut at a 45° angle to it easier to slide them into the slot.
5. When the ink has dried, slide the labeling strips into the slot up to the end of the guide.
The image below shows the guides and labeling strips for the bottom two rows of keys on
the KP1200 Comfort.
① Guide; the maximum number of guides depends on the HMI device used
② Labeling strips
To Next Page
Loading...
