Mounting and connecting the HMI device
3.3 Connecting the device
Comfort Panels
54 Operating Instructions, 03/2012, A5E03404994-02
Attaching a strain relief
With the 4" and 7" models, protect the cables with a separate strain relief. Attach the strain
relief to the HMI device.
The following figure shows the fixing elements of the strain relief for the 4" model:
① Borehole for Torx screw
The strain relief is secured with the Torx screw of the connection for equipotential bonding.
Before you attach the strain relief, unscrew the Torx screw.
② Safety nose
Proceed as follows:
1. Position the strain relief flush with the HMI device.
2. Push the strain relief to the right.
3. Secure the strain relief with the Torx screw.
To Next Page
Loading...
