Siemens SIMATIC KP400 Comfort - Page 84

Commissioning the device
4.4 Configuring the device
Comfort Panels
84 Operating Instructions, 03/2012, A5E03404994-02
Requirement
The Control Panel is open.
Procedure
Proceed as follows:
1. Open the ""OP Properties" " dialog with the "OP". icon.
2. Open to the "Touch" tab.
3. Calibrate the touch screen with "Recalibrate".
The following dialog opens:
&DUHIXOO\SUHVVDQGEULHIO\KROGVW\OXVRQWKHFHQWHURI
WKHWDUJHW5HSHDWDVWKHWDUJHWPRYHVDURXQGWKHVFUHHQ

4. 4" to 12" models: Briefly touch the center of the calibration crosshairs. The calibration
crosshairs appear at the next position.
15" to 22" models: Touch the center of the calibration crosshairs until they appear at the
next position.