Siemens SIMATIC NET CP 1604 - 10-Pin Connector

Description of the device
1.1 CP 1604 communications processor
CP 1604 / CP 1616
16 Operating Instructions, 02/2017, C70000-G8976-C218-08
1.1.3
10-pin connector
Description
The 10-pin connector (PE) is used to signal the PROFIenergy commands to the host PC. As
of firmware V2.6, the CP 1604 allows operation as a PROFIenergy device. With suitable
commands from the PROFINET controller, the PC in which the CP 1604 is plugged in can be
turned off and on again with the aim of reducing energy consumption. The device is turned
off by certain commands (data records) on the IO-Base user programming interface. You will
find these commands in the "IO-Base User Programming Interface" document.
Note
Hardware version for 10-pin connector
The 10
-pin connector is available as of hardware version 7 (MLFB 6GK1160-4AA01).