Installation
5.7 General notes for SFP transceivers
SCALANCE XM-400
54 Operating Instructions, 09/2018, C79000-G8976-C306-08
General notes for SFP transceivers
Use only approved SFP transceivers
If you use SFP transceivers that have not been approved by Siemens AG, there is no
guarantee that the device will function according to its specifications.
If you use unapproved SFP transceivers, this can lead to the following problems:
• Damage to the device
• Loss of the approvals
• Violation of the EMC regulations
Use only approved pluggable transceivers.
Note
Plugging and pulling during operation
You can plug and pull pluggable transceivers with the device in operation.
Documentation for SFP transceivers
You will find detailed information in the operating instructions of the pluggable transceivers,
see the chapter "Introduction (Page 5)" section "Additional documentation".
To Next Page
Loading...
