Approvals
SCALANCE XM-400
86 Operating Instructions, 09/2018, C79000-G8976-C306-08
The devices meet the requirements if you adhere to the installation and safety instructions
contained in this documentation and in the following documentation when installing and
operating the devices.
● "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
(https://support.industry.siemens.com/cs/ww/en/view/27069465
)
● "Industrial Ethernet / PROFINET - Passive Network Components" System Manual
(https://support.industry.siemens.com/cs/ww/en/view/84922825
)
● "EMC Installation Guidelines" configuration manual
(https://support.industry.siemens.com/cs/ww/en/view/60612658
)
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
Note
The test was performed with a device and a connected communications partner that also
meets the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with these
standards, adherence to the
corresponding values cannot be guaranteed.
To Next Page
Loading...
Need help?
General