Siemens SIMATIC NET - Redundant Ring Configurations with Two OLMs

Certification
6.1.7ISO
Note
This equipment has no right to be protected from harmful interference and may not
cause interference in duly authorized systems.
6.1.7 ISO
This device was designed and manufactured using a certified ISO (International
Organization for Standardization) quality program that adheres to the following
standard:
• ISO 9001:2015
Quality management systems – Requirements
6.1.8 RoHS
This device is declared by Siemens AG to meet the requirements of the following
RoHS (Restriction of Hazardous Substances) directives for the restricted use of certain
hazardous substances in electrical and electronic equipment:
• China RoHS 2
Administrative Measure on the Control of Pollution Caused by Electronic
Information Products
A copy of the Material Declaration is available online at https://
support.industry.siemens.com/cs/ww/en/view/109738831.
6.1.9 Other Approvals
This device meets the requirements of the following additional standards:
• IEEE 1613
IEEE Standard Environmental and Testing Requirements for Communications
Networking Devices in Electric Power Substations
• IEC 61000-6-2
Electromagnetic Compatibility (EMC) – Part 6-2: Generic Standards – Immunity
for Industrial Environments
• IEC 61850-3
Communication Networks and Systems in Substations – Part 3: General
Requirements
52
RUGGEDCOM RX1511
Installation Manual, 04/2021, C79000-G8976-1056-20