Siemens SIMATIC PN/J1939 LINK - Introduction; 1.1 Preface; Knowledge required

SIMATIC PN/J1939 LINK
Operating Instructions, 12/2018, A5E45307564-AA
5
Introduction
1
1.1
Preface
Purpose of this documentation
These operating instructions contain all information for configuring, installation,
commissioning and operation of the PN/J1939 LINK.
These operating instructions are intended for qualified personnel in the following target
groups:
● Commissioning engineers
● Operating and service personnel
● System integrator
Knowledge required
The following knowledge is required in order to understand the operating instructions:
● Knowledge of programming a SIMATIC S7 controller
● Knowledge in the application of the TIA configuration environment
● Knowledge of working with the PROFINET fieldbus
● Well-founded knowledge in the SAE J1939 communication protocol
● General knowledge in the field of automation technology
● General knowledge of communication networks
Trademarks
SIMATIC
®
is a registered trademark of Siemens AG.
History
Edition
Note
12/2018 First edition
Naming conventions
The term "PN/J1939 LINK" or "device" is used in this documentation instead of the full
product name "SIMATIC PN/J1939 LINK".
The term "S7 controller", or "S7" for short, is also used for the SIMATIC S7 controller.