Siemens SIMATIC PN/J1939 LINK - Appendix; Certificates and Approvals; A.1 Certificates and Approvals

SIMATIC PN/J1939 LINK
Operating Instructions, 12/2018, A5E45307564-AA
69
Appendix
A
A.1
Certificates and approvals
Note
Approvals are only valid when marked on the product
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the followin
g approvals have been granted for your product by the
markings on the type plate.
CE marking
SIMATIC PN/J1939 LINK device fulfills the requirements and protection objectives of the
following EC directives.
EMC Directive 2014/30/EU
The product is designed for operation in residential and industrial areas.
EMC requirements:
Field of application
Noise emission requirements
Interference immunity requirements
Residential area
EN 61000-6-3
--
Industrial area
EN 61000-6-4
EN 61000-6-2
The product meets these requirements if you adhere to the installation guidelines and safety
instructions included in these operating instructions and in the system manual of the
S7-1200 automation system during installation and operation.
General approvals
The current approvals for the PN/J1939 LINK are listed in the Siemens Mall.