Maintenance
7.3 Backup and Restore Tool
CPU 1505SP (F) Ready4Linux Version 2.7
74 Operating Instructions, 05/2019, A5E46864285-AA
Restore (-r; --restore)
This parameter restores the target hard disk with a base image or backup image. The
parameter restores the first three partitions. To restore the base image, enter the following
command line:
./s7-restore-tool -i ../CPU1505SPF.img -d /dev/sda -r
● ../CPU1505SPF.img
Path of the base image.
● /dev/sdc
Hard disk that is being recovered.
To also overwrite the CPU data on the fourth partition, add the parameter "-o".
Note
Use the created backup image.
If you have created additional backup images on the USB restore flash drive, make sure you
use the correct image path.
To Next Page
Loading...
