Siemens Simatic S7-1500 - Reference Information; Permitted Commands; Parameters

CPU 1505SP (F) Ready4Linux Version 2.7
96 Operating Instructions, 05/2019, A5E46864285-AA
Reference information
A
A.1 Permitted commands / parameters
To configure and operate the CPU, various commands and parameters are available for the
respective tools. This section lists the commands and parameters of the individual tools.
Commands / parameters in the CPU Control tool
To be able to use the commands, start the CPU Control tool with "./s7_cpu_control".
Command
Explanation
--PowerOnCPU Starts the CPU in "STOP" mode.
--PowerOffCPU Shut down the CPU.
Run this command before shutting down Linux. Refer to the section "CPU
behavior when shutting down the operating system (Page 75)".
--Run
Sets the CPU to "RUN" operating mode.
--Stop
Sets the CPU to "STOP" operating mode.
--GetStatus
Shows the operating state of the CPU.
--MemoryReset
Resets the CPU memory.
--FactoryReset
Resets the CPU to the factory setting.
--IP: Identifies and stores the IP address of the runtime communication interface.
Execute this command if the IP address already assigned has changed due
to a download via STEP 7.
To be able to use the parameters, start the CPU Control tool with "./s7_cpu_control".
Parameter
Explanation
--Force
Skips the warning and sets the CPU to the "STOP" operating mode.
--Help
Displays the infotext in the command line editor.
Parameters in the Management tool for MAC addresses
To be able to use the parameters, start the Management tool with "./s7_vnic_macconfig".
Parameter
Explanation
-m
--mount-path
Parent directory of "SWCPU".
-t --target Specifies the interface whose MAC address is changed.
• LINUX: Siemens RT-VMM network adapter
• SWCPU: Runtime communication interface
-a
--mac-addr
Assigns a new MAC address.
-d
--default-mac
Assigns default value for MAC address.
-h
--help
The help and an example of how to use the tool are displayed.