Siemens SIMODRIVE 611-D - Page 134

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–126
SINUMERIK 840C / SIMODRIVE 611–D (DA)
120017 Transmission aborted OK softkey
The user has aborted data transfer with softkey.
The data have not been transferred or only incompletely.
–
Select another file, restart transmission.
Applies as from SW 4.4
120018 Error in channel no. / TO area OK softkey
The channel no. or TO area entered is not permissible with the NC source specified.
File is not transferred.
None
Correct number.
120019 Name ... not allowed OK softkey
An illegal file name has been entered.
The file with the name is not created on the MMC side.
Letters A...Z, numbers 0...9 and the underscore character are permissible.
Please enter the correct name, e.g. ABC _123
120020 There is no data/part program OK softkey
The error occurred while a file was being transferred.
File has not been transferred or only partially.
–
–
120021 Error in NCK name OK softkey
The error occurred while a file was being transferred.
File has not been transferred or only partially.
The name for the NC is incorrect. It consists of an NC identifier (RPA for R parameter) and the channel number,
e.g.: R parameter for channel 2  name = RPA2
Correct the name and/or channel number
120022 No read/write access for ... OK softkey
The error occurred while transferring a file.
File has not been transferred or only partially.
–
Set keyswitch for data.
120023 Memory on NC is full OK softkey
An error occurred during transfer of a file.
File has not been transferred or only partially.
The NC part program is full.
If necessary, delete part programs from the memory.
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description