Preface
1FT6 Synchronous Motors
vi Configuration Manual, (PFT6), 10.2005 Edition, 6SN1197-0AD02-0BP1
Table -1: Technical Support_normal
Technical support
If you have any questions, please contact the following Hotline:
Please send any questions about the documentation (e.g. suggestions for improvement, cor-
rections) to the following fax number or email address:
Information on the products
Up-to-date information about our products can be found on the Internet at the following
address:
Table -2: Danger and warning information
Danger and warning information
Tel.: +49 (0) 180 5050–222
Fax: +49 (0) 180 5050–223
Internet: http://www.siemens.com/automation/support-request
Fax: +49 (0) 9131 98–63315
Fax form: Refer to the correction sheet at the end of the document
E-mail: motioncontrol.docu@siemens.com
http://www.siemens.com/motioncontrol
Danger
Start-up/commissioning is absolutely prohibited until it has been completely ensured that the
machine, in which the components described here are to be installed, is in full compliance
with the specifications of Directive 98/37/EC.
Only appropriately qualified personnel may commission SIMODRIVE and SIMOVERT MAS-
TERDRIVES drive units and the motors.
This personnel must carefully observe the technical customer documentation associated with
this product and be knowledgeable about and carefully observe the danger and warning infor-
mation.
Operational electrical equipment and motors have parts and components which are at haz-
ardous voltage levels.
When the machine or system is operated, hazardous axis movements can occur.
All of the work carried out on the electrical machine or system must be carried out with it in a
no-voltage condition.
SIMODRIVE and SIMOVERT MASTERDRIVES drive units have been designed to be con-
nected to line supplies grounded through a low-ohmic connection (TN line supplies). For addi-
tional information please refer to the appropriate documentation for the drive converter
systems.
To Next Page
Loading...
Need help?
General
