Commissioning
4.4 Setting up a STEP 7 project
Connecting the SIMODRIVE 611U to the Technology CPU
Product Information, 03/2008, A5E00272066-05
19
● Enter the desired cycle time, e.g. 3 ms in the isochronous DP cycle field. The other
described settings are all shown for a DP cycle of 3 ms.
● Click on OK to confirm your settings. The configured objects are then added to the
SIMATIC 300 station.
Figure 4-8 SIMATIC 300 Station
Note
The X1-MPI/DP interface in the rack is not networked for this example. It is set by default
for MPI communication at 187.5 Kbaud. To load the technology system data to the
module, the transmission speed of the interface should be set to ≥ 1.5 Mbaud.
To Next Page
Loading...
