Commissioning
4.5 Drive configuration for SIMODRIVE 611U
Connecting the SIMODRIVE 611U to the Technology CPU
62 Product Information, 03/2008, A5E00272066-05
Figure 4-42 SimoCom U: Option boxes
ā In the basic window of the SimoCom U, call the Configuration > Reconfigure drive menu
items to select the prompted drive configuration.
Note
If you use a double axis module, you must perform the following procedure twice, for
Drive A and Drive B. However, you must ensure that the PROFIBUS address setting is
applicable to both drives. In addition, the same PROFIBUS message frame must be used
for both drives.
Figure 4-43 SimoCom U: Basic window
To Next Page
Loading...
