Siemens SIMOGEAR BA 2330 - Primed Version

Paint system Description
Corrosiveness category C4 for high environmental stress
2‑component epoxy zinc phosphate base
coat,
2‑component polyurethane top coat
• Indoor and outdoor installation
• Chemical plants, swimming pools, wastewater treat‐
ment plants, electroplating shops, and boathouses
above seawater
• Industrial areas and coastal areas with moderate salt
levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid(10%), caustic soda(10%)
Paint system Description
Corrosiveness category C5 for very high environmental stress
2‑component epoxy zinc phosphate base
coat,
2‑component polyurethane intermediate
coat,
2‑component polyurethane top coat
• Indoor and outdoor installation
• Buildings and areas with almost constant condensa‐
tion and high levels are contamination, e.g.malt fac‐
tories and aseptic areas
• Industrial areas with high humidity and aggressive at‐
mosphere, coastal areas and o󹪜shore environments
with high salt levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid(10%), caustic soda(20%)
In case of corrosiveness category C1, overpainting with a 1‑component hydrosystem after
prior rubbing down is possible.
In case of corrosiveness categories C2toC5, overpainting with 2‑component polyurethane
paint, 2‑component epoxide paint and 2‑component acrylic paint after prior rubbing down is
possible.
4.9.3 Primed version
Primer according to corrosiveness category
Paint system Can be overpainted with
Unpainted corrosiveness category C1
Cast iron parts immersion primed,
steel parts primed or zinc-plated,
aluminum and plastic parts untreated
• Synthetic paint, synthetic resin paint, oil paint
• 2‑component polyurethane paint
• 2‑component epoxy paint
Technical description
4.9Surface treatment
Motors for mounting onto SIMOGEAR gearboxes
Operating Instructions, 01/2024, A5E53220841A/RS-AA 61