Siemens SIMOGEAR BA 2330 - Incoming Goods, Transport, and Storage; Incoming Goods; Transport; General Information on Transport

Incoming goods, transport, and storage
5
5.1 Incoming goods
NOTICE
Transport damage
Neither install nor commission damage products
Note
If you do not install the product immediately, do not remove or damage any of the packaging
because this serves as preservation and/or corrosion protection
Note
Check that the technical speci󹪝cations are in accordance with the purchase order.
Inspect the delivery immediately on arrival for completeness and any transport damage.
When you receive the goods, immediately check them for any transport damage. Immediately
report any transport damage that is identi󹪝ed to the transport company.
The gearbox or geared motor is delivered in a fully assembled condition. Additional items are
shipped in separate packaging if applicable.
The products supplied are listed in the dispatch papers.
5.2 Transport
5.2.1 General information on transport
NOTICE
The use of force will damage the gearbox or geared motor
Transport the gearbox or geared motor carefully. Avoid knocks.
Before putting the drive into operation, remove any transport 󹪝xtures and keep them safe or
render them ine󹪜ective. You can then use them again for transporting further items or you can
apply them again.
Di󹪜erent forms of packaging may be used, depending on the size of the gearbox or geared
motor and the method of transport. Unless contractually agreed otherwise, the seaworthy
Motors for mounting onto SIMOGEAR gearboxes
Operating Instructions, 01/2024, A5E53220841A/RS-AA 63