EasyManuals Logo

Siemens SIMOTION User Manual

Siemens SIMOTION
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
These modules are integrated via the GSD file from the device manufacturer.
Note
Please note that in individual cases further boundary conditions must be fulfilled in order to
integrate a standard slave into SIMOTION. Some modules need "driver blocks", e.g. in the
form of function blocks, which make integration possible or much easier.
For modules approved for use with SIMOTION (e.g. S7-300 module FM 350-1, etc.), these
driver blocks:
Up to V3.2 SP1: SIMOTION Function Library
As of V4.0: SCOUT command library
2.3 The fundamentals of motion control
Position-controlled motion control for servo axes via the onboard drive interface (C230-2, C240)
These enable position-controlled motion control of up to four axes. The C230-2/C240 provides
one analog output per axis for the speed setpoint and one encoder input per axis for the cyclic
measurement of the actual position value.
&RQYHUWHU
$FWXDOSRVLWLRQYDOXH]HURPDUN
(QFRGHU
$FWXDOVSHHGYDOXH
6HUYRPRWRU
6SHHG
FRQWUROOHU
&XUUHQW
FRQWUROOHU
3RZHUXQLW
UHOHDVH
6SHHG
VHWSRLQW
'$&
3RVLWLRQ
FRQWUROOHU
;
;
0
a
;
;
;
&&
Figure 2-4 Servo system with converter, e.g. SIMODRIVE 611 universal, with built-in incremental
encoder
Incremental encoder (C230-2, C240)
For position measurement, the encoders usually connected supply counting pulses according
to their resolution for the distances traveled. These can be rotary encoders or linear scales.
Homing is necessary to determine the absolute position reference.
Description
2.3 The fundamentals of motion control
SIMOTION C
22 Operating Instructions, 11/2016, A5E33441428B

Table of Contents

Other manuals for Siemens SIMOTION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTION and is the answer not in the manual?

Siemens SIMOTION Specifications

General IconGeneral
Power Supply24 V DC
InterfacesPROFIBUS, PROFINET, Ethernet
Product typeControl Unit
SeriesSIMOTION D
Display OutputVGA

Related product manuals