9.3 Module replacement without programming device or PC
Overview
If a defective SIMOTION C has to be replaced without using a PG/PC, you can transfer the
data of the defective module to the new module by simply inserting the micro memory card of
the defective module in the new module.
Requirement
When you commissioned your project, you must have used the menu command "Copy RAM
to ROM" of the SIMOTION SCOUT to save your project to the micro memory card, as described
in the chapter "User memory concept".
The following data are on the micro memory card and can be transferred to the new module:
● Technology packages (TP)
● User data (programs, configuration data, parameterizations, task configuration)
● DP parameters (DP addresses, baud rate)
● IP parameters (IP address, subnet mask, router address)
As the non-volatile data is in a memory within the module, it is lost when the module is replaced.
If the non-volatile data is to be transferred to the new module, it must first be backed up on the
micro memory card of the module to be replaced. The restoration of the non-volatile data must
be triggered via a memory reset on the new module.
Note
If the non-volatile data is not restored, the retain variables are set to their initial values and the
diagnostics buffer with the history from the old module is no longer available.
Maintenance and servicing
9.3 Module replacement without programming device or PC
SIMOTION C
Operating Instructions, 11/2016, A5E33441428B 155
To Next Page
Loading...
Need help?
General
