Commissioning
4.5 Commissioning with STARTER
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
85
Changing parameter values using the expert list
● If you wish to specifically change parameters, then - as shown below - call the expert list;
there, scroll to the parameter and then change its value. You close the expert list by
double clicking on an entry in the STARTER project tree.
Saving settings so that they are not lost when the power fails
All of the changes that you make are temporarily saved in the inverter and are lost the next
time the power supply is switched off. For your changes to be permanently saved in the
inverter, you must save the changes using the
button (RAM to ROM). Before you press
the button, you need to mark the appropriate drive in the project navigator.
Go offline
You can now exit the online connection after the data backup (RAM to ROM) with
"Disconnect from target system".
To Next Page
Loading...
