Siemens SINAMICS G120C DP Manual

3 Setting up and commissioning the application
3.5 Loading the software
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4, 07/2018
15
Copyright  Siemens AG 2018 All rights reserved
No.
Action
Remarks
13.
If the used SINAMICS drive has a
safety configuration, please also
reset it.
1. In “Restore factory setting”
you choose the “Safety
parameters will be reset”
option.
2. Start the function.
3. Enter the previous Safety
password.
4. Confirm with OK.
14.
1. Disconnect the online
connection to SINAMICS
drive.
2. Saving the data to EEPROM
is not necessary at present.
15.
Load the drive configuration into
the SINAMICS G120.
1
2
3
4
All Safety parameters will be reset
1
2

Siemens SINAMICS G120C DP Specifications

General

Protection Rating	IP20
Frequency Range	0 to 650 Hz
Control Modes	V/f, sensorless vector control
Communication Interfaces	PROFIBUS DP
Ambient Temperature	-10 to +50 °C (without derating), -10 to +60 °C (with derating)
Overload Capacity	150 % rated current for 60 s, 200 % rated current for 3 s
Storage Temperature	-40 to +70 °C
Relative Humidity	5% to 95% (non-condensing)
Voltage Range	200 V to 240 V (±10%), 380 V to 480 V (±10%)
Output Voltage	0 V to Supply Voltage