Siemens SINAMICS G120D - Page 53

Commissioning
4.2 Commissioning with the IOP
Getting Started
Getting Started, FW V4.5, A5E03404762A AB
51
11. Input the correct Motor Speed from the motor rating
plate.
This value is given in RPM.
%DVLF&RPPLVVLRQLQJ
0RWRU6SHHG

USP



12. Select to run or disable Motor Data Identification
function.
This function, if active, will not start until the first run
command is given to the Inverter.
%DVLF&RPPLVVLRQLQJ
0RWRU'DWD,G
'LVDEOHG
,GHQWDOOSDUDPHWHUVLQVWD

13. Select either zero pulse on no zero pulse for the
attached encoder.
If no encoder is fitted to the motor, the option will not be
displayed.
%DVLF&RPPLVVLRQLQJ
(QFRGHU7\SH
:LWKRXW]HURSXOVH
:LWK]HURSXOVH

14. Enter the correct pulses per revolution for the encoder.
This information is normally printed on the casing of the
encoder.
%DVLF&RPPLVVLRQLQJ
(QFRGHU3XOVHVSHU5HY

3XOVHV



15. Select the macro that is suitable for your application.
Once selected all inputs, outputs, command sources
and setpoints will be automatically configured by the
software.
For further information see the section that details the
precise settings for each macro. Please see installation
section of this manual.
%DVLF&RPPLVVLRQLQJ
0DFUR6RXUFH
6WDQGDUG,2ZLWKDQDORJV
6WDQGDUG,2ZLWKDQDORJD
3URFHVV,2
ZLUHIZGUHY
ZLUHIZGUHY
ZLUHHQDEOHIZGUHY
